WALX-014 SD70MAC Rebuild Kit Installation
General Questions
Q: My panels came warped:
A: Occasionally, with thiner parts they tend to warp. We recommend a small piece of brass sheeting ( K&S Models ) cut to size will reinforce the backs of them to keep them straight
Q: Do You offer the Dynamic brake :
A: During research of this product we found that the existing dynamic brake fan was raised higher to accomodate the new taller panels as shown in the diagrams below
On all 4 sides of your locomotive, the following pieces in green have to be cut out
In order to fit the new panels, the Dynamic brake hatch has to be cut and lifted to fit the top of the new panel , You will have a gap that can be filled with styrene. Also holes can also be filled with putty once done
On the engineer side rear near the handbrake, This will be the location of this style panel.
**FOR THE CONDUCTOR SIDE THIS WILL BE REVERSED AND OPPOSITE SIDE **
Also on the ENGINEER side behind cab door, this style panel will go here.
FOR THE CONDUCTOR SIDE THIS WILL BE REVERSED AND OPPOSITE SIDE
ENGINEER SIDE
CONDUCTOR SIDE